Magnetic Kill Switch Installation

How to Install Your Tether for Maximum Durability

In some crashes, the tether can break if not installed properly. Follow these steps to keep it strong and reliable over time:

1. Cut a 2 cm long piece of 1 mm heat shrink tubing.

2. Insert the tether loosely through the heat shrink.

3. Feed the tether into the magnet.

4. Loop the tether around the plastic connector.

5. Slide the heat shrink so the loop is as small and tight as possible.

6. Pull the tether tight to secure the connection.

7. Apply heat to shrink the tubing and lock everything in place.

8. Clip on your lanyard — you're ready to ride!